Hi Thusitha,

When you open the sub-method “groove and over sizing:

The sub-method that’s high lighted is the copy of the original method that is saved in the cabinet you are designing:

In the example below this sub-method is named DEFAUT@Cabinet3:

If I change a value in this sub-method it only applies to the cabinet3 I’m working on. The DEFAUT sub-method in the library remains unchanged.

When I start another new cabinet that uses the DEFAUT sub-method (in the library) it will use the old values.

To make the change permanently in the library I must high light the original DEFAUT sub-method:

If I now edit the values these will be changed in the original library so that if I start a new cabinet, the library method will be applied.

I hope this is clear.

If not please consider buying a one to one training pack and we will be able to work through these questions in more detail.

You can buy training from this page of our web site:

https://wooddesigner.org/train…..g-service/

best regards,

Ness

Hi Thusitha,

This is probably because you have changed the value in the sub-method copy within the cabinet but the general sub-method in the library is not changed.

To make the change in the library select the library sub-method and not the method-name@cabinet-name.

All the best,

Ness