Wood Designer forum
framed shelve?panel in polyboard-lite|Page 2|Forum|WOOD DESIGNER
Home
Ness:
I tried my hand at design in 5 and transfer to 6. Somewhere I have an error I’ll have towork around.
PLEASE PROCESS CUT LIST FOR THE ATTACHED DESIGN.
Thanks, Jack
October 4, 2012
Offline
Hi Jack,
Exactly!
Design in v5 free version and then open in Lite v6 to get the cutting lists.
Best regards,
Ness
Hi Ness: I have Lite 6. But, I have Poly 5. Guess I need to design in 5 and reopen in 6?
October 4, 2012
Offline
Hi both,
I’m sorry to say that the version Polyboard Lite is limited to only making rectangular cabinets without hardware and panel structures.
To use Lite for other shapes with structured panels you must design in the free version and open the project in Lite. This will enable you to edit the cutting lists and eventually change sizes.
Note also that it’s not possible to install the same release of Polyboard Lite and the free version on the same computer so either you have to have the free version on another computer or you have to install and older release of the free version.
ie. if you have Polyboard 6 lite then you can install Polyboard 5 free on the same computer.
The table you show can easily be made in the free version but not in Polyboard lite.
What release of Polyboard lite do you have Jack?
Best regards,
Ness
1 Guest(s)
