Wood Designer forum
Stair file|Page 2|Forum|WOOD DESIGNER
Home
Hi.I uploaded the wrong stair last time,this is the right file,for this i want the stair file please.
Hi Michel!
Thank you for the adjustments! I shortened the first flight,so there is more headrom. The central cutrstrings must be 10 by 10 because i will made it from steel, 10\10\0.5 cm
Im not sure if i will use the handrail ,so its fine how you made the adjustments( thank you).
i have a final question: is there a way to design the surrounding walls? I
Any way thank you for your help i think its the final version now .
bellow i uploaded the stair.
best regards Attila
August 7, 2014
Offline
Hi Tamas,
I have a few remarks.
The central springboard should be at least 200 width to carry the load properly. I suppose they will be in wood.
The first newel did not reach the floor, so I extended it.
There is no penetration from the steps in the newel. I advise this to ensure vertical stability.
The way the handrail is positioned, the bannisters are not completely on top of the steps. I would advise offsetting the handrail more inside.
About the top newel. I suppose this is extended on the floor and is not part of the stair, so I assume you are not using any landing step but your floor as last step. That means that the base height of the newel is supposed to be on floor level ( 2800 mm)
Warning. The headroom control gives you a passage of 1810 mm only. Reducing the first flight in length ( about 300mm)is the only way to allow more ( 2010 mm)
I attached the stair for you to evaluate.
Regards
Michel
1 Guest(s)
