Wood Designer forum
Top end of stringer extends above stair height|Forum|WOOD DESIGNER
Wim
Forum Posts: 3
Subscriber Since:
September 10, 2019
September 10, 2019
Offline
Good Afternoon All,
As I am relatively new to StairDesigner the issue I have is most likely a result of my incompetence, but nevertheless I am going to pose the question as I just cannot find the answer.
I go to the properties of the stair on the right side of the menu(while in 3D view), I go to “Stringboard parameters”. Then sub-menu “Position above Nosing”.
I have set the offset to 50mm. (Otherwise the tread will touch the edge of the stringer on the foward side.)
This also causes the stair to extend above the preset height of the stair. Please see picture attached.
I am sure I am missing something, but there should be a way to not let the stringers extend…
Any pointers in the right direction would be greatly appreciated!
Cheers!
Wim
Forum Timezone: Europe/London
Most Users Ever Online: 365
Currently Online:
Guest(s) 21
Top Posters:
Ness: 1939
Tom Cleaver: 162
mark nichols: 160
Conor Devoy: 145
brendan kavanagh: 141
Duayne Naugle: 130
Blake Simpson: 104
Zaheer Abbas: 100
Patrick Maylor: 64
Robert Coxhead: 63
Newest Members:
alkisgr
Johannes Hellesøy
charalampous.m@outlook.com
Jarek Nurkowski
p33t
Zallo
Cormack Fallon
wimpie33
Rune Fagerli
IAN GILLIGAN
Forum Stats:
Groups: 2
Forums: 7
Topics: 2200
Posts: 11941
Member Stats:
Guest Posters: 4
Members: 316
Moderators: 0
Admins: 11
Administrators: Stefan, Michel, Carole, Alex, admin, Laly, ipatrick, Crystal, Fatima, Darren, Isaac
© Simple:Press —